Category: MPLS

An IOS device configured for IP+MPLS routing uses three different Maximum Transmission Unit (MTU) values:

• The hardware MTU configured with the mtu interface configuration command
• The IP MTU configured with the ip mtu interface configuration command
• The MPLS MTU configured with the mpls mtu interface configuration command

The hardware MTU specifies the maximum packet length the interface can support … or at least that's the theory behind it. In reality, longer packets can be sent (assuming the hardware interface chipset doesn't complain); therefore you can configure MPLS MTU to be larger than the interface MTU and still have a working network. Oversized packets might not be received correctly if the interface uses fixed-length buffers; platforms with scatter/gather architecture (also called particle buffers) usually survive incoming oversized packets.

Most MPLS books (mine included) and courses tell you that you have to manually enable MPLS on each interface where you want to run it with the mpls ip interface configuration command. However, this task was significantly simplified in IOS release 12.3(14)T with the introduction of MPLS LDP autoconfiguration. If you use OSPF as the routing protocol in your network, you can use the mpls autoconfig ldp [area number] router configuration command to enable LDP on all interfaces running OSPF (optionally limited to an OSPF area).

One of the hardest troubleshooting problems within an MPLS VPN network has always been finding a broken LSP. While you could (in theory) use the IP ping or traceroute (assuming all hops support ICMP extensions for MPLS), the results are not always reliable… and interpreting them is not so easy. For example, after I've disabled LDP on an interface with the no mpls ip configuration command, the routers in the LSP path still reported outgoing MPLS labels in ICMP replies for a few seconds (until the LDP holddown timer expired on both ends of the link).

As a side note, would you deduce from the printout that the break in the LSP path happened on the router with the IP address 192.168.201.1?

One of the most commonly asked load-sharing-related questions is “can I load-share traffic across unequal-cost links?”. In general, the answer is no. In order to load-share the traffic, you need more than one path to the destination and the only way to get multiple routes toward a destination in the IP routing table is to make them equal-cost (the only notable exception being EIGRP that supports unequal-cost load-sharing with the variance parameter).

There are, however, two cases where you can force unequal traffic split across equal-cost paths toward a destination: when using inter-AS BGP with the link bandwidth parameter, and when using unequal-bandwidth traffic-engineering tunnels.

The MPLS Label Stack Encoding (RFC 3032) specifies two reserved values (among others) that are useful in the last hop of a Label Switched Path (LSP):

• 0: explicit NULL. Can be used in signaling protocols as well as label headers.
• 3: implicit NULL. Used in signaling protocols only. It should never appear in the label stack. Its use in a signaling protocol indicates that the upstream router should perform penultimate hop popping (PHP; remove the top label on the stack).

The implicit NULL should be used whenever possible, as the PHP reduces the amount of lookup required on the last hop of an LSP (sometimes that could mean the difference between hardware and software lookup).